Which commands is necessary to permit SSH or Telnet access to a cisco switch that is otherwise configured for these vty line protocols?
A. transport type all
B. transport output all
C. transport preferred all
D. transport input all
D.define all protocols to use when to connecting to terminal server
Which command shows your active Telnet connections?
A. show session
B. show cdp neighbors
C. show users
D. show queue
Which two states are the port states when RSTP has converged?(choose two)
There are no boot system commands in a router configuration in NVRAM.What is the fallback sequence
that router will use to find an ios during reload?
A. Flash,TFTP server,ROM
C. ROM,NVRAM,TFTP server
D. NVRAM,TFTP server,ROM
E. TFTP server,Flash,NVRAM
Refer to the graphic.A host is connected to switch port Fa0/3 with a crossover cable.The host and switch
have…as shown.However,the port indicator on switch port Fa0/3 is not on,and the host can not communicate with…to vlan 2 on the same switch.Based on the information given.what is the problem?
A. The switch has been assigned an incorrect subnet mask.
B. Switch port FA0/3 is not configured as a trunk port
C. Switch port FA0/3 has been blocked by STP
D. The switch and the hosts must be in the same subnet