Which command encrypts all plaintext passwords?
B. Router(config)#service password-encryption
C. Router#service password-encryption
D. Router# password-encryption
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?
A. show running-config
B. show processes cpu
C. debug all
D. logging host ip address
Which three statements about EIGRP are true?(choose three)
A. EIGRP converges fast RIP because of DUAL and routes that are stored in the topology table.
B. EIGRP uses a hello protocol to establish neighbor relationships
C. EIGRP uses split horizon and reverse poisoning to avoid routing loops.
D. EIGRP uses periodic updates to exchange routing information
E. EIGRP allows routers of different manufacturers to interoperate
F. EIGRP supports VLSM and authentication for routing updates.
G. EIGRP use a broadcast address to send routing information.
Refer to the exhibit.Why dose the telnet connectin fail when a host attempts to connect a remote router?
A. No password was set for tty lines
B. No password was set for aux lines
C. No password was set for vty lines
D. No password was set for cty lines
Refer to the exhibit,The VLAN configuration of S1 is not being in this VTP enabled environment.The VTP
and uplink port configurations for each switch are displayed.Which two command sets,if issued,resolve this
failure and allow VTP to operate as expected?(choose two)
A. S2(config)#vtp mode transparent