Section: Chapter 4: Introduction to Cisco IOS
Refer to the exhibit. Which command would allow the translations to be created on the router?
A. ip nat pool mynats 126.96.36.199 188.8.131.52 prefix-length 19
B. ip nat outside mynats 184.108.40.206 220.127.116.11 prefix-length 19
C. ip nat pool mynats 18.104.22.168 22.214.171.124 prefix-length 18
D. ip nat outside mynats 126.96.36.199 188.8.131.52 prefix-length 18
Section: Chapter 8: NAT
mynats为地址池的名字,prefix-length 表示掩码的长度。prefix-length 19表示掩码为255.255.224.0
Refer to the exhibit. An istrator pings the default gateway at 10.10.10.1 and sees the output as
shown. At which OSI layer is the problem?
A. data link layer
B. application layer
C. access layer
D. session layer
E. network layer
Section: Chapter 2: TCP/IP
Refer to the exhibit. Which value will be configured for Default Gateway of the Local Area Connection?
Section: Chapter 3: IP Addressing and VLSM
Refer to the exhibit. The user at Workstation B reports that Server A cannot be reached. What is preventing Workstation B from reaching Server A?
A. The IP address for Server A is a broadcast address.
B. The IP address for Workstation B is a subnet address.
C. The gateway for Workstation B is not on the same subnet.
D. The gateway for Server A is not on the same subnet.
Section: Chapter 6: IP Routing
Refer to the exhibit. What does the (*) represent in the output?
A. Packet is destined for a local interface to the router.
B. Packet was translated, but no response was received from the distant device.
C. Packet was not translated, because no additional ports are available.
D. Packet was translated and fast switched to the destination.