Section: Chapter 11: Wireless
How does using the service password encryption command on a router provide additional security?
A. by encrypting all passwords passing through the router
B. by encrypting passwords in the plain text configuration file
C. by requiring entry of encrypted passwords for access to the device
D. by configuring an MD5 encrypted key to be used by routing protocols to validate routing exchanges
E. by automatically suggesting encrypted passwords for use in configuring the router
Section: Chapter 4: Introduction to Cisco IOS
Refer to the exhibit. When running OSPF, What would cause router A not to form an adjacency with router
A. The loopback addresses are on different subnets.
B. The value of the dead timers on the router are different.
C. Route summarization is enabled on both routers.
D. The process indentifier on router A is different than the process identifier on router B. Answer: B
Section: Chapter 6: IP Routing
Refer to the exhibit. What statement is true of the configuration for this network?
A. The configuration that is shown provides inadequate outside address space for translation of the number of inside addresses that are supported.
B. Because of the addressing on interface FastEthernet0/1, the Serial0/0 interface address will not support
the NAT configuration as shown.
C. The number 1 referred to in the ip nat inside souce command recerences access-list number 1.
D. ExternalRouter must be configured with static routers to network 172.16.2.0/24
Section: Chapter 8: NAT