Refer to the exhibit. A network istrator configures a new router and enters the copy startup-config
running-config on the router. The network istrator powers down the router and sets it up at a remote
location. When the router starts, it enter the system configuration dialog as shown. What is the caust of the
A. The network istrator faled to save the configuration.
B. The configuration register is set to 0x2100.
C. The boot system flash command is missing from the configuration.
D. The configuraiton register is set to 0x2102.
E. The router is configured with the boot system startup command.
Section: Chapter 4: Introduction to Cisco IOS
管理员并没有使用copy run start命令.所以配置没有被保存.在设备重启后自然就没有配置被调用了
Refer to the exhibit. An organization connect two locations, supporting two VLANs, through two switches as
shown. Inter-VLANs communicated is not required. The network is working properly and there is fully
connectivity. The organization needs to add additional VLANs, so it has been decided to implement VTP.
Both switches are configured as VTP servers in the same VTP domain. VLANs added to Switch1 are not
learned by Switch2. Based on this information and partial configuration is the exhibit, what is the problem?
A. Switch2 should be configured as a VTP client.
B. VTP is Cisco proprietory and requires a different trunking encapsulation
C. A router is required to route VTP advertisements between the swtiches.
D. STP has blocked on of the links between the switches, limiting connectivity.
E. The links between the switches are access links.
Section: Chapter 10: VLAN
The istrator is unable to establish connectivity between two Cisco routers. Upon reviewing the
command output of both routers, what is the most likely caust of the problem?
A. Authentication needs to be changed to PAP for both routers.
B. Serial IP addresses of routers are not on the same subnet.
C. Username/password is incorrectly configured.
D. Router names are incorrectly configured.
Section: Chapter 14: Wide Area Network (W AN)
Refer to the exhibit. The network manager is evaluating the efficiency of the current network design. RIPv2
is enabled on all Layer 3 devices in the network. What network devices participate in passing traffic from
the PC at 10.10.1.7 to File Server at 10.20.1.6 in the older that they will forward traffic from source to
A. Switch1, Switch2