Section: Chapter 11: Wireless
Refer to the exhibit. A network istrator needs to add a new VLAN, named VLAN3, to the network
shown. Unfortunately, there is not another FastEthernet interface on R1 to connect to the new VLAN3.
Which approach is the most cost effective solution for this problem?
A. Purchase a new FastEthernet module and install it on R1
B. Replace R1 with a new router that has at least three FastEthernet interfaces.
C. Configure a second switch to support VLAN3 with a VLAN trunk between SW1 and the new switch.
D. Configure a single VLAN trunk between R1 and SW1 and configure subinterface on R1 interface for
E. Connect another router to a serial interface of R1. Use a FastEthernet interface on the new router for
Section: Chapter 10: VLAN
Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with
A. As numbers must be changed to match on all the routers.
B. Loopback interface must be configured so a DR is elected.
C. The no auto-summary command is needed on Router A and Router C.
D. Router B needs to have two network statements, one for each connected network.
Section: Chapter 6: IP Routing
eigrp的AS号码必须一致.负责将不能够形成邻居关系所以也就不能够进行路由update QUESTION 155
Refer to the exhibit. The two exhibit devices are the only Cisco devices on the network. The serial network
between the two devices has a mask of 255.255.255.252. Given the output that is shown, what three
statements are true of these devices? (Choose three.)
A. The Manchester serial address is 10.1.1.1
B. The Manchester serial address is 10.1.1.2
C. The London router is a Cisco 2610.
D. The Manchester router is a Cisco 2610.
E. The CDP information was received on port Serial0/0 of the Manchester router.
F. The CDP information was sent by port Serial0/0 of the London Router.
Section: Chapter 5: Managing Cisco IOS
How is an EUI-64 format interface ID created from a 48-bit MAC address?