Refer to the exhibit. The output that is shown is generated at a switch. Which three of these statements are
true? (Choose three.)
A. All ports will be in a state of discarding, learning, or forwarding.
B. Thiry VLANs have been configured on this switch.
C. The bridge priority is lower than the default value for spanning tree.
D. All interfaces that are shown are on shared media.
E. All designated ports are in a forwarding state.
F. The switch must be the root bridge for all VLANs on this switch.
Section: Chapter 9: Switching
Refer to the exhibit. A network istrator attempts to ping Host2 from Host1 and receives the result that
are shown. What is a possible problem?
A. The link between Host1 and Switch1 is down.
B. TCP/IP is not functioning on Host1.
C. The link between Router1 and Router2 is down.
D. The default gateway on Host1 is incorrect.
E. Interface Fa0/0 on Router1 is shudown.
F. The link between Switch1 and Router1 is down.
Section: Chapter 6: IP Routing
Refer to the exhibit. The Bigtime router is unable to authenticate to the Littletime router. What is the cause
of the problem?
A. The usernames are incorrectly configured on the two routers.
B. The passwords do not match on the two routers.
C. CHAP authentication cannot be used on a serial interface.
D. The routers cannot be connected from interface S0/0 to interface S0/0.
E. With CHAP authentication, one router must authenticate to another router. The routers cannot be
configured to authenticate to each other.
Section: Chapter 14: Wide Area Network (W AN)
S0/0 on R1 is configured as a multipoint interface to communicate with R2 and R3 in the hub-and-spoke
Frame Relay topology shown in the exhibit. Originally, static routes were configured between these routers
to successfully route traffic between the attached networks. What will need to be done in order to use
RIPv2 in place of the static routes?
A. Configure the no ip subnet-zero command on R1, R2, and R3.