Refer to the graphic. Host 1 cannot receive packets from Host 2. Assuming that RIP v1 is the routing
protocol in use, what is wrong with the IP configuration information shown? (Choose two.)
A. The fa0/1 interface of router R2 has been assigned a broadcast address.
B. The fa0/1 network on router R2 overlaps with the LAN attached to R1.
C. Host 2 has been assigned the incorrect subnet mask.
D. Host 1 has been configured with the 255.255.248.0 subnet mask.
E. Host 2 on router R2 is on a different subnet than its gateway.
Section: Chapter 6: IP Routing
What are three valid reasons to assign ports to VLANs on a switch? (Choose three.)
A. to make VTP easier to implement
B. to isolate broadcast traffic
C. to increase the size of the collision domain
D. to allow more devices to connect to the network
E. to logically group hosts according to function
F. to increase network security
Section: Chapter 10: VLAN
Refer to the topology shown in the exhibit. Which ports will be STP designated ports if all the links are
operating at the same bandwidth? (Choose three.)
A. Switch A - Fa0/0
B. Switch A - Fa0/1
C. Switch B - Fa0/0
D. Switch B - Fa0/1
E. Switch C - Fa0/0
F. Switch C - Fa0/1
Section: Chapter 9: Switching