Assuming default setting,how can you erase the VTP database of VLANs on a CISCO IOS switch running
in VTP server mode?
A. Enable VTP pruning
B. From privileged mode ,erase the startup configuration file,then reload.
C. From privileged mode ,erase the vlan date file, then reload.
D. Cycle the switch power.
Refer to the exhibit.which address and mask combination a summary of the routes learned by EIGRP?
A. 192.168.25.0 255.255.255.240
B. 192.168.25.16 255.255.255.252
C. 192.168.25.0 255.255.255.252
D. 192.168.25.28 255.255.255.240
E. 192.168.25.16 255.255.255.240
F. 192.168.25.28 255.255.255.240
Refer to the exhibit A frame on vlan 1on switch s1 is sent to switch s2 when the frame is received on vlan
2,what causes this behavior?
A. trunk mode mismatches
B. vlans that do not correspond to a unique IP subnet
C. native vlan mismatches
D. allowing only vlan 2 on the destination.
Refer to the exhibit.The network istrator normally establishes a telnet session with the switch from
host A.However,host A is unavailable.The istrator′s attempt to the switch from host B fails,but pings
to the other two hosts are successful.what is the issue?
A. Host B and the switch need to be in the same subnet.
B. The switch needs and appropriate default gateway assigned.
C. The switch interface connected to the router is down.
D. Host B need to be assigned an IP address in vlan 1.
远程管理交换机需要在交换机上设置default gateway和vlan IP
What value is primarily used to determine which port becomes the root port on each nonroot switch in a
A. lowest port MAC address